O'Neil patches shallow holes and divots with Ready Patch because it dries fast, sands smooth, and stays flexible. Deep cracks and rotten spots are best repaired with two-step epoxies, such as those made by Advanced Repair Technology. (For a step-by-step instructions, see Repairing Rot with Epoxy.) The days of using polyester auto-body fillers on wood are over. "They cure too hard," says Portland, Oregon–based painting contractor Kathleen George. "They look good at first, but then they peel away."
Our house had not been painted in 27 years. When Robert Palladino and Mike were done the house looked better than new! Workmanship was excellent. They showed up on schedule and worked hard every day (even in 93 degree heat) until the job was done. I had no idea that contractors of this caliber still existed. My wife and I could not be happier with the quality of the work and the cost. You will not regret hiring this company.
For smoothing the edges of scraped spots here and there, you can wrap a piece of sandpaper around a wood block. For larger areas, it's less tiring and more effective to use an electric orbital sander. Move it up and down or back and forth across the surface to remove old paint and smooth rough edges at the same time. Don't use an electric disc sander or a belt sander. Both can leave swirls or dips in the wood that will show through a new coat of paint.
Use a wire brush and a wide-blade putty knife to remove small areas of defective paint. Scrub under the laps of clapboard siding as well as on downspouts and gutters. For speedier work on metal, a wire brush attachment on an electric drill will remove rust and paint with less effort. For more extensive paint removal, invest in a sharp pull scraper -- a tool with a replaceable blade that's capable of stripping old paint all the way down to bare wood with a single scrape. Hold the scraper so the blade is perpendicular to the wood, apply moderate to firm pressure, and drag it along the surface. Keep the blade flat against the wood so it doesn't gouge the surface.
A fresh coat of paint makes everything it touches seem brand new. But such new beginnings cost real money. Professional painters charge around $4,000 for labor and materials to paint the exterior of a 2,500-square-foot, two-story home and roughly $5,500 for the interior. Painters’ rates may range from $20 to $60 an hour, but around $40 is typical in urban areas.
According to the EPA, professional painters must check for lead -- especially if a home was built before 1978. Many DIY painters forget to test for lead paint. Testing kits are available in home improvement stores for less than $40. You can also hire a lead testing and removal professional to do this work quickly and efficiently on your behalf. Lead paint can be dangerous; it's far better to find it before you put time and effort into painting your home than after the fact.
We use third party data sources to conduct a criminal search, in the state in which the owner/principal of the company is located, for any relevant criminal activity associated with the owner/principal of the business, within the three years prior to such service professional's application for membership in the HomeAdvisor network. HomeAdvisor's third-party vendor uses a national criminal database ("NCD") to screen our service professionals. The comprehensiveness of the NCD varies by state. Please be aware that the reporting in the NCD is particularly limited in the following states: AL, CO, DE, GA, ID, KS, KY, LA, ME, MA, MI, MS, MT, NE, NV, NH, NM, SD, UT, VA, VT, and WY.
The cost to paint the exterior of your home will vary depending on the size of your home, the condition of your siding, type of paint used and other factors. The average cost for labor and supplies ranges between $1,800-$3,800 and it may cost $6,500 or more for a large, custom project. In addition, you may need to pay more if there is damage to your siding or other challenging aspects of your job.